Call now to get tree support just as tree clearance, tree disposal, bush cleanup, shrub lop, stump clearance and many other in USA.


Call us now

Call us now +1 (855) 280-15-30










I've done dozens that way, never had a problem with.

How to easily get that [email protected]? starter bushing out, just be careful NOT to drop anything down in there! Feb 01, Beetle Owner and Reader Beth Leverman, of Dallas, Texas, submitted the following method for Bushing Removal and Installation using tools at hand. Thank you, Beth for working this up and for the photos! To remove the old 12 Volt Starter Bushing, tap the old Bushing using a 7/16ths tap.

Or, you can use a completely threaded bolt and double-nut the bolt to achieve the desired installation length.

If the Bushing will not remove by pulling on the Estimated Reading Time: 1 min. Jan 31, Volkswagen engineers designed a Bushing Puller for the 6 Volt Starter Bushing and another for the 12 Volt Bushing.

Let’s look at the Bushing Location first. In order to do this, I have a VW transmission which has been gutted and cleaned for the purpose. The first picture shows the Long-bodied Starter in place. Keep in mind we've already have changed the starter bushing which is a little bit harder to show or even picture then describe. Anytime you're replacing starter we always recommend that you change the starter bushing. The starter in, the lower starter nuts tight, positive battery cables connected, ignition switch wires connected.

Dec 09, If you haven't damaged the bushing by trying to extract it, consider just greasing the bushing and the starter shaft. Or just taking back the starter and see if they'll swap for a starter from an automatic bug, which is self supporting and doesn't require a bushing at all.

Yes, my starter still operates fine 20 years later too. Feb 21, Although a loose bushing may cause the starter to hang up with similar symptoms to the famous VW hard-start issue, the famous VW hard-start issue does exist for other reasons, too. I fixed a famous VW hard-start issue in the BobD (with certifiably fresh starter bushing) merely by cleaning trans/battery ground paths to sparklingly shiny + DeOx gel. Dec 17, STARTER BUSHING, starter motor shaft to transmission (use this when converting to 12V with a pre transmission.) I don't have a great way to accurately measure the hole size way up in there, but by trying a bunch of different o.d.

sockets in the hole, I estimate that the hole size is about 19/32", right between the (approximately) 17/